# The contents of this file are subject to the Mozilla Public License
# (MPL) Version 1.1 (the "License"); you may not use this file except
# in compliance with the License. You may obtain a copy of the License
# at http://www.mozilla.org/MPL/
#
# Software distributed under the License is distributed on an "AS IS"
# basis, WITHOUT WARRANTY OF ANY KIND, either express or implied. See
# the License for the specific language governing rights and
# limitations under the License.
#
# The Original Code is LEPL (http://www.acooke.org/lepl)
# The Initial Developer of the Original Code is Andrew Cooke.
# Portions created by the Initial Developer are Copyright (C) 2009-2010
# Andrew Cooke (andrew@acooke.org). All Rights Reserved.
#
# Alternatively, the contents of this file may be used under the terms
# of the LGPL license (the GNU Lesser General Public License,
# http://www.gnu.org/licenses/lgpl.html), in which case the provisions
# of the LGPL License are applicable instead of those above.
#
# If you wish to allow use of your version of this file only under the
# terms of the LGPL License and not to allow others to use your version
# of this file under the MPL, indicate your decision by deleting the
# provisions above and replace them with the notice and other provisions
# required by the LGPL License.  If you do not delete the provisions
# above, a recipient may use your version of this file under either the
# MPL or the LGPL License.

'''
Parse (and construct) binary data.

Only Python 3.0+ is supported. 
'''

if bytes is str:
    print('Binary parsing unsupported in this Python version')
else:
    from lepl.bin.bits import Int, unpack_length, BitString, swap_table
    from lepl.bin.literal import parse
    from lepl.bin.encode import dispatch_table, simple_serialiser
    from lepl.bin.matchers import BEnd, Const

    __all__ = [
           
           'Int',
           'BitString',
           'unpack_length',
           'swap_table',
           
           'parse',
           
           'dispatch_table',
           'simple_serialiser',
           
           'BEnd',
           'Const'
    ]