1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59
|
#!/bin/sh
if [ -x ../ao-tools/ao-load/ao-load ]; then
AOLOAD=../ao-tools/ao-load/ao-load
elif [ -x /usr/bin/ao-load ]; then
AOLOAD=/usr/bin/ao-load
else
echo "Can't find ao-load! Aborting."
exit 1
fi
if [ -x ../ao-tools/ao-rawload/ao-rawload ]; then
RAWLOAD=../ao-tools/ao-rawload/ao-rawload
elif [ -x /usr/bin/ao-rawload ]; then
RAWLOAD=/usr/bin/ao-rawload
else
echo "Can't find ao-rawload! Aborting."
exit 1
fi
VERSION=1.0
echo "TeleMini v$VERSION Turn-On and Calibration Program"
echo "Copyright 2011 by Bdale Garbee. Released under GPL v2"
echo
echo "Expectations:"
echo "\tTeleMini v$VERSION powered from LiPo"
echo "\t\twith TeleDongle (on /dev/ttyACM0) cabled to debug header"
echo "\t\twith frequency counter able to sample RF output"
echo
echo -n "TeleMini serial number: "
read SERIAL
echo $RAWLOAD
case $USER in
bdale)
programmer=100
;;
keithp)
programmer=186
;;
esac
$RAWLOAD -D $programmer -r ao_led_blink.ihx
echo "LEDs should be blinking"
sleep 5
$RAWLOAD -D $programmer -r ao_radio_xmit.ihx
echo -n "Generating RF carrier. Please enter measured frequency: "
read FREQ
CAL_VALUE=`nickle -e "floor(434.55 / $FREQ * 1186611 + 0.5)"`
echo "Programming flash with cal value " $CAL_VALUE
$AOLOAD -D $programmer --cal $CAL_VALUE ~/altusmetrumllc/Binaries/telemini-v$VERSION-*.ihx $SERIAL
echo "Serial number "$SERIAL" programmed with RF cal value "$CAL_VALUE
echo "Unplug and replug USB, cu to the board, confirm freq and record power"
|