1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
|
SYSTEM SPECIFICATION
====================
Atari800 is available for both 32-bit (armhf) and 64-bit (arm64) architectures.
It will run on the following systems:
Pi 2 running Pi OS Full 32-bit Bookworm (armhf).
Pi Zero 2 W, 3, 4, 400 and 5, running Pi OS Full 64-bit Bookworm (arm64).
It is also possible to downgrade to Pi OS 32-bit and run the the armhf
version of atari800 on these machines, but this is not recommended.
The Pi 1 and and the single core Zero are not supported. They can run atari800 in
tiny windows, but nothing approaching full screen. Larger images overload their
processors, producing choppy sound and video.
Pi OS Lite is not supported. Atari800 may run OK with Pi OS Lite on certain
machine/monitor combinations, but in general it cannot support proper fullscreen
images running at full speed. At the time of writing (December 2023) it is not
known whether this is a temporary situaton that will be corrected by further
development, or if new software such as the KMS video driver that atari800 depends
upon to run at full speed has been deliberately omitted from the Lite version.
PERFORMANCE LIMITATIONS
=======================
The atari800 menu allows you to select the fullscreen resolution using <F1>,
<Display Settings>, <Video mode settings>, <Fullscreen resolution:>. It defaults
to 640x480, but you can increase it to obtain more accurate representations of
Atari screens. The available selections go right up to the resolution of your
monitor. However, you may find that you overload the processor on some Pis at
a certain point, resulting in choppy audio and video. If this happens, back off
to a lower resolution. To make full use of the screen and preserve the aspect
ratio while you make these adjustments, set <Host display apect ratio:> to
match you monitor (or select <autodetect>), set <image aspect ratio:> to
<authentic> and <Stretch image:> to <fit screen - full>.
The Pi 2 cannot run atari800 at full speed in large windows, but fullscreen is OK.
Hardware graphics acceleration is not required, and should be turned off by default.
It is effective in reducing CPU load on the Pi 3, 4 and 5, but is very detrimental
on other models. Set <F1>, <Display Settings>, <Video mode settings>,
<Hardware acceleration:> to <No>.
The Raspberry Pi Imager offers Ubuntu Desktop 64-Bit as an alternative operating
system, but it imposes higher CPU loading than Pi OS, and is unable to run
atari800 at full speed on most models of Pi.
|
