1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
|
#include "pagestart.h"
<p>BitPim speaks two major protocols with your phone. One is the
official vendor sync protocol which usually only covers most of the
phonebook information and the other is to access the embedded filesystem
in the phone.
<p>For CDMA phones, the latter protocol has a checksum for each command
and response transmitted and received. Some of the synchronization
protocols also have the checksum such as the protocol used for CDMA
LG phones.
<p>If you encounter this error, then it means the data the phone
thinks it sent is not the same as the data received by BitPim.
BitPim detects the problem and immediately stops.
<p>The usual cause is in your cabling and where you plugged it in.
You should ensure your cable is plugged directly into a port on
your computer, not going through a hub. Do not use cable extenders,
gender changes or converters. If you still have problems, use
a different host port. Try reseating your cable at the phone
end. If none of these solve the problem, then the problem may be
your cable.
<p><b>Multi-processor machines:</b> Sometimes this problem is caused
by poor driver behaviour on multi-processor machines. Your machine is
multi processor if you have hyper-threading turned on, or it is dual-core.
You can also tell by running the Task Manager (press ctrl-alt-delete)
and looking in the View menu. If there is a submenu labelled
CPU History that lets you choose one graph or one graph per CPU then
you have a multi-processor machine.
<blockquote><p><b>Editting your <tt>boot.ini</tt> could result in your machine
not booting if you make mistakes. If you run <tt>bootcfg</tt> from a
command prompt, it will list the current operating settings.</b></p></blockquote>
<p>You can reboot your machine and tell Windows to only use one cpu
even if there is more than one in your machine. To do so you will
need to add a line to <tt>boot.ini</tt> and specify the <tt><b>/onecpu</b></tt>
switch. Microsoft has a guide for editting <tt>boot.ini</tt> in
URL(http://support.microsoft.com/?kbid=289022,KB289022). In general
you should copy the first line in the <tt>[operating systems]</tt>
section, add <tt>/onecpu</tt> on the end and edit the text between quotes
to say it is the onecpu line. You may also want to increase the timeout
(seconds) in the <tt>[boot loader]</tt> section. When you reboot, you'll
have that many seconds to pick the onecpu line. You can tell if it worked
by running Task Manager as detailed in the previous paragraph and looking
for the View > CPU History sub-menu.
#include "pageend.h"
|
