1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
|
Last revised: November 29, 2023
.. _transfer:
===============
Transfer Module
===============
The transfer module provides DCC SEND/GET support and userfile transfer
support for userfile sharing.
This module requires: none
Put this line into your Eggdrop configuration file to load the transfer
module::
loadmodule transfer
There are also some variables you can set in your config file:
set max-dloads 3
Set here the maximum number of simultaneous downloads to allow for
each user.
set dcc-block 0
Set here the block size for dcc transfers. ircII uses 512 bytes,
but admits that may be too small. 1024 is standard these days.
Set this to 0 to use turbo-dcc (recommended).
set xfer-timeout 30
Set here the time (in seconds) to wait before an inactive transfer
times out.
set sharefail-unlink 1
By default, Eggdrop will abort the linking process if userfile sharing is
enabled but the userfile transfer fails. Set this to 0 to keep the bots
linked if the userfile transfer fails and retry every minute (both bots must
be v1.9.0 or higher).
Copyright (C) 2000 - 2025 Eggheads Development Team
|
