1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
|
<!DOCTYPE html PUBLIC "-//W3C//DTD HTML 4.01 Transitional//EN">
<html>
<head>
<title>Kantronics KAM (Appendix 4)</title>
</head>
<body background="/back_fbb.jpg">
<h1 align="Center"> Kantronics KAM<small> in host-mode.</small> </h1>
<p align="Center"> (Appendix 4) </p>
<pre> If you plan to use a KAM with this software, you must make some changes.<br><br><font color="#ff0000">For WinFBB:</font>
Use interface 6 in <a href="fmtport.htm">PORT.SYS</a>.<br><br><font color="#ff0000">For DosFBB:</font>
Before you start the BBS, you must load the RS232 driver. You must use
ESSKAM or ESS (ESS must be version 1.10 or higher). Do not use another
driver such as COMBIOS or MBBIOS.
Run it like this:
ESSKAM 1 (Com1, Address and IRQ = defaults)
ESSKAM 1 03F8 4 (Com1, Address=03F8Hex, IRQ4)
The KAM must be in the right baudrate, and in hostmode. You put it into
hostmode with these commands:
INTF HOST
PERM
There is a special format for INITTNCx.SYS. For HF, use this:
UNPROTO MAIL/
MONITOR ON/
MCOM ON/
MCON ON/
MRESP ON/
PID ON/
RETRY 15/
RESPTIM 0/
FRACK 2/
CHECK 30/
HID OFF/
For VHF use this:
UNPROTO /MAIL
MONITOR /ON
MCOM /OFF
MCON /ON
MRESP /ON
PID /ON
RETRY /8
CHECK /30
HID /OFF
As you can see, the position of the "/" is very important for HF/VHF !
In PORT.SYS you must use 1 for VHF and 2 for HF in MultCh. You must also use
K in "Type host-mode".
#
# Same number of lines as number of TNCs.
#
#TNC NbCh Com MultCh Pacl Maxfr NbFwd MxBloc M/P-Fwd Mode Freq
1 4 1 1 230 4 1 10 30/60 UKYW 144.675
2 1 1 2 80 1 1 6 15/60 UKYW HF
#
<font color="#800000">This page was last updated 17-Apr-99</font>
</pre>
</body>
</html>
|
