1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
|
### Device installation
#### Linux
##### Cutters with a parallel interface
Cutters with a parallel interface (either a 'real' parallel port or using a
built-in parallel-to-USB converter) must be added to your system as a printer
before using them from Inkcut. Start your printer configuration utility (e.g.
[system-config-printer](http://cyberelk.net/tim/software/system-config-printer)),
which at least when connecting via USB should detect the connected cutter.
Proceed to add it with the 'Generic' 'Raw Queue' driver.
#### OS X
##### Cutters with a parallel interface
Cutters with a parallel interface (either a 'real' parallel port or using a
built-in parallel-to-USB converter) must be added to your system as a printer
before using them from Inkcut.
Enable the CUPS web interface by executing `cupsctl WebInterface=yes` on the
command line. Then visit the admin interface on http://127.0.0.1:631/admin and
add a printer using an admin username and password. Select the relevant 'local
printer', continue and select 'Raw' for the 'Make' and 'Raw Queue' for the
model.
### Device Setup
Choose `Device -> Setup...` from the menu. Select your device driver from the list.
> Note: If your device is not in the list, use the `Inkcut Generic Driver`.
Select the `Connection` tab and choose the connection type. Finally choose the language your device uses in the `Protocols` tab. Click `Ok` to save your changes.
### Speed settings
Inkcut attempts to send data to the device at a rate that will not cause the device's data buffer to overflow on large jobs.
For this to work properly it is important that the speed setting matches the actual device speed.
### Output rotation
You can change final output scaling and rotation that Inkcut uses for your device under the `Output` tab within the `Device` tab.
### Quality factor
When cutting small jobs some intricate details may be lost in the conversion from curves to polygon segments.
The default `Quality factor` of `1` can be adjusted in the `Advanced` tab to increase the number of points used. Increasing this to `5` for instance gives a noticable improvement for this example.
Be careful however as this can signifcantly increase the number of points sent to the device.
### Add missing device
The list of supported devices from the old website was moved to a google spreadsheet [here](https://docs.google.com/spreadsheets/d/1KYNZMkNy0qYcpnXaNHgXKvdEhnUYKfGqZOH0Dw6siAg/). These must also be added into Inkcut
for them to display in the device dropdown list.
If you would like to add a missing device, please create an issue and provide the following:
- Manufacturer
- Model name
- Supported protocols
- Supported connection types
- Width and length of the plotting area
|
