This library implements the serial commands supported by the Celestron
NexStar hand control (HC) and SkyWatcher/Orion SynScan HC. This applies
to the Celestron: NexStar GPS, NexStar GPS-SA, NexStar iSeries, NexStar
SE Series, NexStar GT, CPC, SLT, Advanced-VX, Advanced-GT, CGE, CGEM etc.
SkyWatcher: EQ5, HEQ5, EQ6 (Pro), AZ-EQ5 GT, AZ-EQ6 GT, EQ8 etc. and the
corresponding Orion mounts.
Communication to the hand control is 9600 bits/sec, no parity and one
stop bit via the RS-232 port on the base of the hand control.
Communication can be established over TCP/IP if nexbridge is running
on the computer connected to the telescope.
NOTE: For SkyWatcher/Orion mounts it is highly recommended to enforce
protocol version checking (see enforce_protocol_version()) as the AUX
commands are not supported or may behave erratically.
COPYRIGHT AND LICENCE
Copyright (C) 2013-2016 by Rumen G.Bogdanovski
This library is free software, you can redistribute it and/or modify
it under the terms of GPL3
The author assumes no liability or responsibility for damage or injury
to persons or property arising from any use of this product. Use it at
your own risk.