1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
|
#ifndef _ATM_CONFIG_H
#define _ATM_CONFIG_H
@TOP@
/*
acconfig.h
*/
/*
Default config file location for atmsigd
*/
#define ATMSIGD_CONF "/usr/local/etc/atmsigd.conf"
#undef YY_USE_CONST
/*
The UNI version can be configured at run time. Dynamic is the default. Use the
explicit version selections only in case of problems.
*/
#undef DYNAMIC_UNI
#undef UNI30
/*
Note: some UNI 3.0 switches will show really strange behaviour if confronted
with using 3.1 signaling, so be sure to test your network *very*
carefully before permanently configuring machines to use UNI 3.1.
*/
#undef UNI31
#undef ALLOW_UNI30
/*
Some partial support for UNI 4.0 can be enabled by using UNI40
*/
#undef UNI40
/*
If using UNI40, you can also enable peak cell rate modification as
specified in Q.2963.1
*/
#undef Q2963_1
/*
If you're using a Cisco LS100 or LS7010 switch, you should add the following
line to work around a bug in their point-to-multipoint signaling (it got
confused when receiving a CALL PROCEEDING, so we don't send it, which of
course makes our clearing procedure slightly non-conformant):
*/
#undef CISCO
/*
Some versions of the Thomson Thomflex 5000 won't do any signaling before they
get a RESTART. Uncomment the next line to enable sending of a RESTART
whenever SAAL comes up. Note that the RESTART ACKNOWLEDGE sent in response to
the RESTART will yield a warning, because we don't implement the full RESTART
state machine.
*/
#undef THOMFLEX
/*
Use select() instead of poll() with MPOA
*/
#undef BROKEN_POLL
/*
Use proposed MPOA 1.1 features
*/
#undef MPOA_1_1
@BOTTOM@
#endif
|
