1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
|
config INFINIBAND_IPOIB
tristate "IP-over-InfiniBand"
depends on NETDEVICES && INET && (IPV6 || IPV6=n)
---help---
Support for the IP-over-InfiniBand protocol (IPoIB). This
transports IP packets over InfiniBand so you can use your IB
device as a fancy NIC.
See Documentation/infiniband/ipoib.txt for more information
config INFINIBAND_IPOIB_CM
bool "IP-over-InfiniBand Connected Mode support"
depends on INFINIBAND_IPOIB
default n
---help---
This option enables support for IPoIB connected mode. After
enabling this option, you need to switch to connected mode
through /sys/class/net/ibXXX/mode to actually create
connections, and then increase the interface MTU with
e.g. ifconfig ib0 mtu 65520.
WARNING: Enabling connected mode will trigger some packet
drops for multicast and UD mode traffic from this interface,
unless you limit mtu for these destinations to 2044.
config INFINIBAND_IPOIB_DEBUG
bool "IP-over-InfiniBand debugging" if EXPERT
depends on INFINIBAND_IPOIB
default y
---help---
This option causes debugging code to be compiled into the
IPoIB driver. The output can be turned on via the
debug_level and mcast_debug_level module parameters (which
can also be set after the driver is loaded through sysfs).
This option also creates a directory tree under ipoib/ in
debugfs, which contains files that expose debugging
information about IB multicast groups used by the IPoIB
driver.
config INFINIBAND_IPOIB_DEBUG_DATA
bool "IP-over-InfiniBand data path debugging"
depends on INFINIBAND_IPOIB_DEBUG
---help---
This option compiles debugging code into the data path
of the IPoIB driver. The output can be turned on via the
data_debug_level module parameter; however, even with output
turned off, this debugging code will have some performance
impact.
|
