1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 158 159 160 161 162 163 164 165 166 167 168 169 170 171 172 173 174 175 176 177 178 179 180 181 182 183 184 185 186 187 188 189 190 191 192 193 194 195 196 197 198 199 200 201 202 203 204 205 206 207 208 209 210 211 212 213 214 215 216 217 218 219 220 221 222 223 224 225 226 227 228 229 230 231 232 233 234 235 236 237 238 239 240 241 242 243 244 245 246 247
|
/*
* board-flash.c
* Modified from mach-omap2/board-3430sdp-flash.c
*
* Copyright (C) 2009 Nokia Corporation
* Copyright (C) 2009 Texas Instruments
*
* Vimal Singh <vimalsingh@ti.com>
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
#include <linux/kernel.h>
#include <linux/platform_device.h>
#include <linux/mtd/physmap.h>
#include <linux/io.h>
#include <plat/irqs.h>
#include <plat/gpmc.h>
#include <plat/nand.h>
#include <plat/onenand.h>
#include <plat/tc.h>
#include "board-flash.h"
#define REG_FPGA_REV 0x10
#define REG_FPGA_DIP_SWITCH_INPUT2 0x60
#define MAX_SUPPORTED_GPMC_CONFIG 3
#define DEBUG_BASE 0x08000000 /* debug board */
/* various memory sizes */
#define FLASH_SIZE_SDPV1 SZ_64M /* NOR flash (64 Meg aligned) */
#define FLASH_SIZE_SDPV2 SZ_128M /* NOR flash (256 Meg aligned) */
static struct physmap_flash_data board_nor_data = {
.width = 2,
};
static struct resource board_nor_resource = {
.flags = IORESOURCE_MEM,
};
static struct platform_device board_nor_device = {
.name = "physmap-flash",
.id = 0,
.dev = {
.platform_data = &board_nor_data,
},
.num_resources = 1,
.resource = &board_nor_resource,
};
static void
__init board_nor_init(struct mtd_partition *nor_parts, u8 nr_parts, u8 cs)
{
int err;
board_nor_data.parts = nor_parts;
board_nor_data.nr_parts = nr_parts;
/* Configure start address and size of NOR device */
if (omap_rev() >= OMAP3430_REV_ES1_0) {
err = gpmc_cs_request(cs, FLASH_SIZE_SDPV2 - 1,
(unsigned long *)&board_nor_resource.start);
board_nor_resource.end = board_nor_resource.start
+ FLASH_SIZE_SDPV2 - 1;
} else {
err = gpmc_cs_request(cs, FLASH_SIZE_SDPV1 - 1,
(unsigned long *)&board_nor_resource.start);
board_nor_resource.end = board_nor_resource.start
+ FLASH_SIZE_SDPV1 - 1;
}
if (err < 0) {
pr_err("NOR: Can't request GPMC CS\n");
return;
}
if (platform_device_register(&board_nor_device) < 0)
pr_err("Unable to register NOR device\n");
}
#if defined(CONFIG_MTD_ONENAND_OMAP2) || \
defined(CONFIG_MTD_ONENAND_OMAP2_MODULE)
static struct omap_onenand_platform_data board_onenand_data = {
.dma_channel = -1, /* disable DMA in OMAP OneNAND driver */
};
static void
__init board_onenand_init(struct mtd_partition *onenand_parts,
u8 nr_parts, u8 cs)
{
board_onenand_data.cs = cs;
board_onenand_data.parts = onenand_parts;
board_onenand_data.nr_parts = nr_parts;
gpmc_onenand_init(&board_onenand_data);
}
#else
static void
__init board_onenand_init(struct mtd_partition *nor_parts, u8 nr_parts, u8 cs)
{
}
#endif /* CONFIG_MTD_ONENAND_OMAP2 || CONFIG_MTD_ONENAND_OMAP2_MODULE */
#if defined(CONFIG_MTD_NAND_OMAP2) || \
defined(CONFIG_MTD_NAND_OMAP2_MODULE)
/* Note that all values in this struct are in nanoseconds */
static struct gpmc_timings nand_timings = {
.sync_clk = 0,
.cs_on = 0,
.cs_rd_off = 36,
.cs_wr_off = 36,
.adv_on = 6,
.adv_rd_off = 24,
.adv_wr_off = 36,
.we_off = 30,
.oe_off = 48,
.access = 54,
.rd_cycle = 72,
.wr_cycle = 72,
.wr_access = 30,
.wr_data_mux_bus = 0,
};
static struct omap_nand_platform_data board_nand_data = {
.gpmc_t = &nand_timings,
};
void
__init board_nand_init(struct mtd_partition *nand_parts,
u8 nr_parts, u8 cs, int nand_type)
{
board_nand_data.cs = cs;
board_nand_data.parts = nand_parts;
board_nand_data.nr_parts = nr_parts;
board_nand_data.devsize = nand_type;
board_nand_data.ecc_opt = OMAP_ECC_HAMMING_CODE_DEFAULT;
board_nand_data.gpmc_irq = OMAP_GPMC_IRQ_BASE + cs;
gpmc_nand_init(&board_nand_data);
}
#endif /* CONFIG_MTD_NAND_OMAP2 || CONFIG_MTD_NAND_OMAP2_MODULE */
/**
* get_gpmc0_type - Reads the FPGA DIP_SWITCH_INPUT_REGISTER2 to get
* the various cs values.
*/
static u8 get_gpmc0_type(void)
{
u8 cs = 0;
void __iomem *fpga_map_addr;
fpga_map_addr = ioremap(DEBUG_BASE, 4096);
if (!fpga_map_addr)
return -ENOMEM;
if (!(__raw_readw(fpga_map_addr + REG_FPGA_REV)))
/* we dont have an DEBUG FPGA??? */
/* Depend on #defines!! default to strata boot return param */
goto unmap;
/* S8-DIP-OFF = 1, S8-DIP-ON = 0 */
cs = __raw_readw(fpga_map_addr + REG_FPGA_DIP_SWITCH_INPUT2) & 0xf;
/* ES2.0 SDP's onwards 4 dip switches are provided for CS */
if (omap_rev() >= OMAP3430_REV_ES1_0)
/* change (S8-1:4=DS-2:0) to (S8-4:1=DS-2:0) */
cs = ((cs & 8) >> 3) | ((cs & 4) >> 1) |
((cs & 2) << 1) | ((cs & 1) << 3);
else
/* change (S8-1:3=DS-2:0) to (S8-3:1=DS-2:0) */
cs = ((cs & 4) >> 2) | (cs & 2) | ((cs & 1) << 2);
unmap:
iounmap(fpga_map_addr);
return cs;
}
/**
* board_flash_init - Identify devices connected to GPMC and register.
*
* @return - void.
*/
void board_flash_init(struct flash_partitions partition_info[],
char chip_sel_board[][GPMC_CS_NUM], int nand_type)
{
u8 cs = 0;
u8 norcs = GPMC_CS_NUM + 1;
u8 nandcs = GPMC_CS_NUM + 1;
u8 onenandcs = GPMC_CS_NUM + 1;
u8 idx;
unsigned char *config_sel = NULL;
/* REVISIT: Is this return correct idx for 2430 SDP?
* for which cs configuration matches for 2430 SDP?
*/
idx = get_gpmc0_type();
if (idx >= MAX_SUPPORTED_GPMC_CONFIG) {
pr_err("%s: Invalid chip select: %d\n", __func__, cs);
return;
}
config_sel = (unsigned char *)(chip_sel_board[idx]);
while (cs < GPMC_CS_NUM) {
switch (config_sel[cs]) {
case PDC_NOR:
if (norcs > GPMC_CS_NUM)
norcs = cs;
break;
case PDC_NAND:
if (nandcs > GPMC_CS_NUM)
nandcs = cs;
break;
case PDC_ONENAND:
if (onenandcs > GPMC_CS_NUM)
onenandcs = cs;
break;
};
cs++;
}
if (norcs > GPMC_CS_NUM)
pr_err("NOR: Unable to find configuration in GPMC\n");
else
board_nor_init(partition_info[0].parts,
partition_info[0].nr_parts, norcs);
if (onenandcs > GPMC_CS_NUM)
pr_err("OneNAND: Unable to find configuration in GPMC\n");
else
board_onenand_init(partition_info[1].parts,
partition_info[1].nr_parts, onenandcs);
if (nandcs > GPMC_CS_NUM)
pr_err("NAND: Unable to find configuration in GPMC\n");
else
board_nand_init(partition_info[2].parts,
partition_info[2].nr_parts, nandcs, nand_type);
}
|