1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 158 159 160 161 162 163 164 165 166 167 168 169 170 171 172 173 174 175 176 177 178 179 180 181 182 183 184 185 186 187 188 189 190 191 192 193 194 195 196 197 198 199 200 201 202 203 204 205 206 207 208 209 210 211 212 213 214 215 216 217 218 219 220 221 222 223 224 225 226 227 228 229 230 231 232 233 234 235 236 237 238 239 240 241 242 243 244 245 246 247 248 249 250 251 252 253 254 255 256 257 258 259 260 261 262 263 264 265 266 267 268 269 270 271 272 273 274
|
// SPDX-License-Identifier: GPL-2.0+
/*
* DRM driver for Ilitek ILI9486 panels
*
* Copyright 2020 Kamlesh Gurudasani <kamlesh.gurudasani@gmail.com>
*/
#include <linux/backlight.h>
#include <linux/delay.h>
#include <linux/gpio/consumer.h>
#include <linux/module.h>
#include <linux/property.h>
#include <linux/spi/spi.h>
#include <video/mipi_display.h>
#include <drm/drm_atomic_helper.h>
#include <drm/drm_drv.h>
#include <drm/drm_fb_helper.h>
#include <drm/drm_gem_atomic_helper.h>
#include <drm/drm_gem_dma_helper.h>
#include <drm/drm_managed.h>
#include <drm/drm_mipi_dbi.h>
#include <drm/drm_modeset_helper.h>
#define ILI9486_ITFCTR1 0xb0
#define ILI9486_PWCTRL1 0xc2
#define ILI9486_VMCTRL1 0xc5
#define ILI9486_PGAMCTRL 0xe0
#define ILI9486_NGAMCTRL 0xe1
#define ILI9486_DGAMCTRL 0xe2
#define ILI9486_MADCTL_BGR BIT(3)
#define ILI9486_MADCTL_MV BIT(5)
#define ILI9486_MADCTL_MX BIT(6)
#define ILI9486_MADCTL_MY BIT(7)
/*
* The PiScreen/waveshare rpi-lcd-35 has a SPI to 16-bit parallel bus converter
* in front of the display controller. This means that 8-bit values have to be
* transferred as 16-bit.
*/
static int waveshare_command(struct mipi_dbi *mipi, u8 *cmd, u8 *par,
size_t num)
{
struct spi_device *spi = mipi->spi;
void *data = par;
u32 speed_hz;
int i, ret;
__be16 *buf;
buf = kmalloc(32 * sizeof(u16), GFP_KERNEL);
if (!buf)
return -ENOMEM;
/*
* The displays are Raspberry Pi HATs and connected to the 8-bit only
* SPI controller, so 16-bit command and parameters need byte swapping
* before being transferred as 8-bit on the big endian SPI bus.
* Pixel data bytes have already been swapped before this function is
* called.
*/
buf[0] = cpu_to_be16(*cmd);
gpiod_set_value_cansleep(mipi->dc, 0);
speed_hz = mipi_dbi_spi_cmd_max_speed(spi, 2);
ret = mipi_dbi_spi_transfer(spi, speed_hz, 8, buf, 2);
if (ret || !num)
goto free;
/* 8-bit configuration data, not 16-bit pixel data */
if (num <= 32) {
for (i = 0; i < num; i++)
buf[i] = cpu_to_be16(par[i]);
num *= 2;
speed_hz = mipi_dbi_spi_cmd_max_speed(spi, num);
data = buf;
}
gpiod_set_value_cansleep(mipi->dc, 1);
ret = mipi_dbi_spi_transfer(spi, speed_hz, 8, data, num);
free:
kfree(buf);
return ret;
}
static void waveshare_enable(struct drm_simple_display_pipe *pipe,
struct drm_crtc_state *crtc_state,
struct drm_plane_state *plane_state)
{
struct mipi_dbi_dev *dbidev = drm_to_mipi_dbi_dev(pipe->crtc.dev);
struct mipi_dbi *dbi = &dbidev->dbi;
u8 addr_mode;
int ret, idx;
if (!drm_dev_enter(pipe->crtc.dev, &idx))
return;
DRM_DEBUG_KMS("\n");
ret = mipi_dbi_poweron_conditional_reset(dbidev);
if (ret < 0)
goto out_exit;
if (ret == 1)
goto out_enable;
mipi_dbi_command(dbi, ILI9486_ITFCTR1);
mipi_dbi_command(dbi, MIPI_DCS_EXIT_SLEEP_MODE);
msleep(250);
mipi_dbi_command(dbi, MIPI_DCS_SET_PIXEL_FORMAT, 0x55);
mipi_dbi_command(dbi, ILI9486_PWCTRL1, 0x44);
mipi_dbi_command(dbi, ILI9486_VMCTRL1, 0x00, 0x00, 0x00, 0x00);
mipi_dbi_command(dbi, ILI9486_PGAMCTRL,
0x0F, 0x1F, 0x1C, 0x0C, 0x0F, 0x08, 0x48, 0x98,
0x37, 0x0A, 0x13, 0x04, 0x11, 0x0D, 0x0);
mipi_dbi_command(dbi, ILI9486_NGAMCTRL,
0x0F, 0x32, 0x2E, 0x0B, 0x0D, 0x05, 0x47, 0x75,
0x37, 0x06, 0x10, 0x03, 0x24, 0x20, 0x00);
mipi_dbi_command(dbi, ILI9486_DGAMCTRL,
0x0F, 0x32, 0x2E, 0x0B, 0x0D, 0x05, 0x47, 0x75,
0x37, 0x06, 0x10, 0x03, 0x24, 0x20, 0x00);
mipi_dbi_command(dbi, MIPI_DCS_SET_DISPLAY_ON);
msleep(100);
out_enable:
switch (dbidev->rotation) {
case 90:
addr_mode = ILI9486_MADCTL_MY;
break;
case 180:
addr_mode = ILI9486_MADCTL_MV;
break;
case 270:
addr_mode = ILI9486_MADCTL_MX;
break;
default:
addr_mode = ILI9486_MADCTL_MV | ILI9486_MADCTL_MY |
ILI9486_MADCTL_MX;
break;
}
addr_mode |= ILI9486_MADCTL_BGR;
mipi_dbi_command(dbi, MIPI_DCS_SET_ADDRESS_MODE, addr_mode);
mipi_dbi_enable_flush(dbidev, crtc_state, plane_state);
out_exit:
drm_dev_exit(idx);
}
static const struct drm_simple_display_pipe_funcs waveshare_pipe_funcs = {
.mode_valid = mipi_dbi_pipe_mode_valid,
.enable = waveshare_enable,
.disable = mipi_dbi_pipe_disable,
.update = mipi_dbi_pipe_update,
};
static const struct drm_display_mode waveshare_mode = {
DRM_SIMPLE_MODE(480, 320, 73, 49),
};
DEFINE_DRM_GEM_DMA_FOPS(ili9486_fops);
static const struct drm_driver ili9486_driver = {
.driver_features = DRIVER_GEM | DRIVER_MODESET | DRIVER_ATOMIC,
.fops = &ili9486_fops,
DRM_GEM_DMA_DRIVER_OPS_VMAP,
.debugfs_init = mipi_dbi_debugfs_init,
.name = "ili9486",
.desc = "Ilitek ILI9486",
.date = "20200118",
.major = 1,
.minor = 0,
};
static const struct of_device_id ili9486_of_match[] = {
{ .compatible = "waveshare,rpi-lcd-35" },
{ .compatible = "ozzmaker,piscreen" },
{},
};
MODULE_DEVICE_TABLE(of, ili9486_of_match);
static const struct spi_device_id ili9486_id[] = {
{ "ili9486", 0 },
{ }
};
MODULE_DEVICE_TABLE(spi, ili9486_id);
static int ili9486_probe(struct spi_device *spi)
{
struct device *dev = &spi->dev;
struct mipi_dbi_dev *dbidev;
struct drm_device *drm;
struct mipi_dbi *dbi;
struct gpio_desc *dc;
u32 rotation = 0;
int ret;
dbidev = devm_drm_dev_alloc(dev, &ili9486_driver,
struct mipi_dbi_dev, drm);
if (IS_ERR(dbidev))
return PTR_ERR(dbidev);
dbi = &dbidev->dbi;
drm = &dbidev->drm;
dbi->reset = devm_gpiod_get(dev, "reset", GPIOD_OUT_HIGH);
if (IS_ERR(dbi->reset))
return dev_err_probe(dev, PTR_ERR(dbi->reset), "Failed to get GPIO 'reset'\n");
dc = devm_gpiod_get(dev, "dc", GPIOD_OUT_LOW);
if (IS_ERR(dc))
return dev_err_probe(dev, PTR_ERR(dc), "Failed to get GPIO 'dc'\n");
dbidev->backlight = devm_of_find_backlight(dev);
if (IS_ERR(dbidev->backlight))
return PTR_ERR(dbidev->backlight);
device_property_read_u32(dev, "rotation", &rotation);
ret = mipi_dbi_spi_init(spi, dbi, dc);
if (ret)
return ret;
dbi->command = waveshare_command;
dbi->read_commands = NULL;
ret = mipi_dbi_dev_init(dbidev, &waveshare_pipe_funcs,
&waveshare_mode, rotation);
if (ret)
return ret;
drm_mode_config_reset(drm);
ret = drm_dev_register(drm, 0);
if (ret)
return ret;
spi_set_drvdata(spi, drm);
drm_fbdev_generic_setup(drm, 0);
return 0;
}
static void ili9486_remove(struct spi_device *spi)
{
struct drm_device *drm = spi_get_drvdata(spi);
drm_dev_unplug(drm);
drm_atomic_helper_shutdown(drm);
}
static void ili9486_shutdown(struct spi_device *spi)
{
drm_atomic_helper_shutdown(spi_get_drvdata(spi));
}
static struct spi_driver ili9486_spi_driver = {
.driver = {
.name = "ili9486",
.of_match_table = ili9486_of_match,
},
.id_table = ili9486_id,
.probe = ili9486_probe,
.remove = ili9486_remove,
.shutdown = ili9486_shutdown,
};
module_spi_driver(ili9486_spi_driver);
MODULE_DESCRIPTION("Ilitek ILI9486 DRM driver");
MODULE_AUTHOR("Kamlesh Gurudasani <kamlesh.gurudasani@gmail.com>");
MODULE_LICENSE("GPL");
|