1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
|
# ==== Purpose ====
#
# Test verifies that, due to a temporary network error, if request dump
# command specific packet write operation fails then the write error gets
# handled appropriately. Further retry will be initiated with appropriate
# slave registration on master. This will ensure that master has all the
# details of slave and no warnings are reported on the master side.
#
# ==== Implementation ====
#
# Steps:
# 0 - Skip the slave start.
# 1 - Enable debug simulation which will simulate packet write error during
# dump request command execution.
# 2 - Start the slave. Observe that slave is able to reconnect post
# temporary network write error.
#
# ==== References ====
#
# MDEV-14203: rpl.rpl_extra_col_master_myisam,
# rpl.rpl_slave_load_tmpdir_not_exist failed in buildbot with a
# warning
#
# MDEV-13258: rpl.rpl_skip_replication, rpl.rpl_set_statement_default_master
# failed in buildbot
#
--source include/have_debug.inc
--source include/have_debug_sync.inc
--let $rpl_skip_start_slave=1
--source include/master-slave.inc
--disable_query_log
call mtr.add_suppression("Could not read packet:.* errno: 11");
--enable_query_log
# Do an insert on master
CREATE TABLE t1(a int);
INSERT INTO t1 VALUES(1);
# Add a debug point and start the slave so that dump request fails.
connection slave;
SET @saved_dbug = @@GLOBAL.debug_dbug;
SET @@global.debug_dbug= 'd,simulate_error_on_packet_write';
START SLAVE;
SET DEBUG_SYNC= 'now WAIT_FOR parked';
SET @@GLOBAL.debug_dbug = @saved_dbug;
SET DEBUG_SYNC= 'now SIGNAL continue';
# Ensure the last DEBUG_SYNC signal was received by the target thread before
# reset; otherwise, the reset can drop the last signal before it gets
# acknowledged
let $wait_condition= select count(*)=0 from information_schema.processlist where state like "%debug%";
source include/wait_condition.inc;
SET DEBUG_SYNC= 'RESET';
--source include/wait_for_slave_io_to_start.inc
--source include/wait_for_slave_sql_to_start.inc
# Sync the slave and verify that slave has caught up with the master.
connection master;
--source include/sync_slave_sql_with_master.inc
SELECT * FROM t1;
# Cleanup
connection master;
DROP TABLE t1;
--source include/rpl_end.inc
|
