1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
|
# HOWTO entry is too long
Module: 3c59x
3c59x debug=1 options=0,,12
This sets the debug message level to minimal messages,
sets the first card to the 10baseT transceiver, the second
to the EEPROM-set transceiver, and the third card to operate
in full-duplex mode using its 100baseTx transceiver.
(Note: card ordering is set by the PCI BIOS.)
Possible media type settings:
0 10baseT 1 10Mbs AUI 2 undefined
3 10base2 (BNC) 4 100base-TX 5 100base-FX
6 MII (not yet available) 7 <Use default setting>
8 Full-duplex bit
16 Bus-master enable bit (experimental use only!)
For details see the top of the source file.
Module: g_NCR5380
g_NCR5380
ncr_irq=xx the interrupt (254 to autoprobe)
ncr_addr=xx the port or base address (for port or
memory mapped, resp.)
ncr_dma=xx the DMA (255 for none, 254 for overriding
ncr_5380=1 to set up for a NCR5380 board
ncr_53c400=1 to set up for a NCR53C400 board
modprobe g_NCR5380 ncr_irq=5 ncr_addr=0x350 ncr_5380=1
- for a port mapped NCR5380 board or
modprobe g_NCR5380 ncr_irq=255 ncr_addr=0xc8000 ncr_53c400=1
- for a memory mapped NCR53C400 board with interrupts disabled.
Module: sbpcd
sbpcd sbpcd=0x230,1
IO address, e.g. 0x230
CD-ROM interface type: 0 ... LaserMate
1 ... SoundBlaster
2 ... SoundScape
3 ... Teac16bit
See Documentation/cdrom/sbpcd for more details.
Module: tulip
NoParams:
tulip
Module: umsdos
NoParams:
umsdos
|
