1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
|
<!DOCTYPE HTML SYSTEM "html.dtd">
<HTML><HEAD><TITLE>Example 6 </TITLE></HEAD>
<BODY>
<H2><center>Example 6</center></h2>
<p>The geometry data for the cylinder with attached wires was discussed in
section III-2. The wire on the end of the cylinder is excited first and a
trdiation pattern is computed. The CP card requests the coupling between the
base segments of the two wirs. hence agter the second wire has been excited,
the table "ISOLATION DATA" is printed. The coupling printed is the maximum that
would occur when the source and load are simultaneously matched to there
antennas. The table includes the matched load impedance for the second segment
and the corresponding input impedance at the firs segment. The source impedance
would be the conjugate of this input impedance for maximum coupling.
<hr>
</body>
</html>
|
