1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
|
#
# SPDX-License-Identifier: GPL-2.0-only
#
try:
from ns import ns
except ModuleNotFoundError:
raise SystemExit(
"Error: ns3 Python module not found;"
" Python bindings may not be enabled"
" or your PYTHONPATH might not be properly configured"
)
# // Default Network Topology
# //
# // 10.1.1.0
# // n0 -------------- n1
# // point-to-point
# //
ns.LogComponentEnable("UdpEchoClientApplication", ns.LOG_LEVEL_INFO)
ns.LogComponentEnable("UdpEchoServerApplication", ns.LOG_LEVEL_INFO)
nodes = ns.NodeContainer()
nodes.Create(2)
pointToPoint = ns.PointToPointHelper()
pointToPoint.SetDeviceAttribute("DataRate", ns.StringValue("5Mbps"))
pointToPoint.SetChannelAttribute("Delay", ns.StringValue("2ms"))
devices = pointToPoint.Install(nodes)
stack = ns.InternetStackHelper()
stack.Install(nodes)
address = ns.Ipv4AddressHelper()
address.SetBase(ns.Ipv4Address("10.1.1.0"), ns.Ipv4Mask("255.255.255.0"))
interfaces = address.Assign(devices)
echoServer = ns.UdpEchoServerHelper(9)
serverApps = echoServer.Install(nodes.Get(1))
serverApps.Start(ns.Seconds(1))
serverApps.Stop(ns.Seconds(10))
address = interfaces.GetAddress(1).ConvertTo()
echoClient = ns.UdpEchoClientHelper(address, 9)
echoClient.SetAttribute("MaxPackets", ns.UintegerValue(1))
echoClient.SetAttribute("Interval", ns.TimeValue(ns.Seconds(1)))
echoClient.SetAttribute("PacketSize", ns.UintegerValue(1024))
clientApps = echoClient.Install(nodes.Get(0))
clientApps.Start(ns.Seconds(2))
clientApps.Stop(ns.Seconds(10))
ns.Simulator.Run()
ns.Simulator.Destroy()
|
