1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
|
Template: setserial/autosave
Type: boolean
Default: true
Description: Do you want the automatic serial port configuration?
All releases of setserial since 2.15 use the file /etc/serial.conf to
configure the serial ports. You can edit it to your own likings, or use the
automatic serial port configuration, which is the recommended way of doing
it.
.
Attention PCMCIA users - pcmcia-cs has its own configuration for PC Card
serial-type devices, which is not compatible with setserial. In case of
problems, please read the /usr/share/doc/setserial/README.Debian.gz file.
Template: setserial/autosave-types
Type: select
Choices: autosave once, manual, autosave always
Default: autosave once
Description: Type of automatic serial port configuration to use?
Setserial contains the ability to save your current serial configurations, but
you have to decide the method which setserial is to use.
.
autosave once - this saves your serial configuration the first time you select
this option, using kernel information. From this point on this information is
never changed automatically again. If you want the configuration to change
you have to edit serial.conf by hand. This is the default and is good in
almost all cases.
.
manual - control serial.conf yourself right from the start. Good for experts
who like to get their hands dirty, but autosave-once is probably still better.
.
autosave always - save the serial configuration on every system shutdown,
and reload the saved state when you reboot. Good if you change your serial
configuration a lot, but DANGEROUS as rebooting a system with "errors"
can result in the complete loss of your serial configuration!
Template: setserial/rc-boot-file-renamed
Type: note
Description: Please read documentation on old 0setserial entries
You have an old-style 0setserial entry. The configuration mechanism
has changed completely after setserial release 2.14.
.
Your old /etc/rc.boot/0setserial file was just renamed to to
0setserial.pre-2.15.
.
Read /usr/share/doc/setserial/README.Debian.gz file for more information.
Template: setserial/rc-boot-file-removed
Type: note
Description: New method of bootup initialization used
You have an old-style 0setserial entry. The configuration mechanism
has changed completely after setserial release 2.14.
.
Your old /etc/rc.boot/0setserial file was removed.
The /etc/init.d/setserial file is used instead.
Template: setserial/update-modules-failed
Type: note
Description: update-modules failed!
WARNING: setserial tried to install the module management code to support
the serial.o module being loaded and unloaded dynamically by kerneld (or
its equivalent). However, update-modules failed to allow its installation.
.
There may be something non-standard about your module configuration.
You should try running /sbin/update-modules on your own.
|
