1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
|
/*! \page page_usrpctl Usrpctl
\tableofcontents
\section usrpctl_description Description
usrpctl is the central and universal tool to
query, update or configure USRP devices. The command structure is:
usrpctl $ID $COMMAND $OPTIONS
`usrpctl` will run $COMMAND on the devices identified by $ID. $OPTIONS
is dependend on the chosen command.
\section usrpctl_id $ID
$ID is the optional device argument. It is used to define a set
of USRP devices that `$COMMAND` should be applied to. If `$ID` is omitted
$COMMAND is applied to all reachable devices.
`usrpctl` understands the device args argument used by other UHD
tools like `uhd_find_devices`.
\section usrpctl_command $COMMAND
Is the action the tool is to take. Every command can be either applied to a
single device or a group of devices. Commands that run on a group of
devices repeat the command for every device.
- Single device commands:
- `config`: Read/write configuration variables (e.g., IP address)
- `probe`: reads extended information about the USRP
- Multi device commands:
- `update`: Update binaries (e.g., FPGA image)
- `reset`: Reset the device or parts thereof (e.g., only reset MPM)
- `find`: finds all available USRPs in this network
\section usrpctl_options $OPTIONS
The options depend on the chosen command. Optional arguments are prepended
with a dash, mandatory are not.
\section usrpctl_commands Available commands
\section usrpctl_find find
The find command takes no further options. If `$ID` is not given it scans the
system for available, supported devices and prints a list of discovered devices.
The print out is compatible to \ref id_identifying_cmdline "`uhd_find_devices`".
`$ID` can be used to narrow down the list of discovered devices.
Examples:
- `usrpctl find` find all supported devices
- `usrpctl type=x300,product=X310 find` find all x310 devices
- `usrpctl name=my_usrp find` find a device named my_usrp
- `usrpctl addr=192.168.10.2 find` find a device with the given IP.
\subsection usrpctl_probe probe
Arguments:
-`-tree`: print a list of the device property tree
The probe command can only be applied to a single device so make sure that
$ID identifies exactly one device. Without arguments it displays detailed
information about the device such as name, serial, revision numbers,
firmware version sensor information on attached motherboard and daughterboards.
Examples:
- `usrpctl addr=192.168.10.2 probe` display device information for USRP with the given ID
- `usprctl name=my_usrp probe -tree` display property tree of device with the name my_usrp
*/
// vim:ft=doxygen:
|
