1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
|
<?xml version='1.0' encoding='UTF-8'?>
<!DOCTYPE topic PUBLIC "-//OASIS//DTD DITA Topic//EN" "topic.dtd">
<topic xml:lang="en-us" id="vboxwebsrv-solaris">
<title>Oracle Solaris: Starting the Web Service With SMF</title>
<body>
<p>On Oracle Solaris hosts, the <ph conkeyref="vbox-conkeyref-phrases/product-name"/> web service daemon is
integrated into the SMF framework. You can change the parameters, but do not have to if the defaults below already
match your needs: </p>
<pre xml:space="preserve">svccfg -s svc:/application/virtualbox/webservice:default setprop config/host=localhost
svccfg -s svc:/application/virtualbox/webservice:default setprop config/port=18083
svccfg -s svc:/application/virtualbox/webservice:default setprop config/user=root</pre>
<p>The table in <xref href="vboxwebsrv-linux.dita#vboxwebsrv-linux"/> showing the parameter names and defaults also
applies for Oracle Solaris. The parameter names must be changed to lowercase and a prefix of
<codeph>config/</codeph> has to be added. For example: <codeph>config/user</codeph> or
<codeph>config/ssl_keyfile</codeph>. If you make any change, do not forget to run the following command to put
the changes into effect immediately: </p>
<pre xml:space="preserve">svcadm refresh svc:/application/virtualbox/webservice:default</pre>
<p>If you forget the above command then the previous settings are used when enabling the service. Check the current
property settings as follows: </p>
<pre xml:space="preserve">svcprop -p config svc:/application/virtualbox/webservice:default</pre>
<p>When everything is configured correctly you can start the <ph conkeyref="vbox-conkeyref-phrases/product-name"/>
web service with the following command: </p>
<pre xml:space="preserve">svcadm enable svc:/application/virtualbox/webservice:default</pre>
<p>For more information about SMF, please refer to the Oracle Solaris documentation. </p>
</body>
</topic>
|
