1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
|
Source: xc3sprog
Section: electronics
Priority: optional
Maintainer: Ricardo Ribalda Delgado <ricardo@ribalda.com>
Build-Depends: cmake, debhelper (>= 11), libftdi1-dev, libusb-dev, pkg-config
Standards-Version: 4.2.1
Homepage: http://xc3sprog.sourceforge.net/
Vcs-Browser: https://sourceforge.net/p/xc3sprog/code/HEAD/tree/
Vcs-Svn: https://svn.code.sf.net/p/xc3sprog/code/
Rules-Requires-Root: no
Package: xc3sprog
Architecture: any
Depends: ${shlibs:Depends}, ${misc:Depends}
Description: JTAG flashing tool for FPGAs, CPLDs and EEPROMs
xc3sprog is a suite of utilities for programming Xilinx FPGAs, CPLDs, and
EEPROMs with the Xilinx Parallel Cable and other JTAG adapters under Linux.
xc3sprog runs as a command-line application.
.
The main features include:
- Reading a .BIT file from Xilinx design tools and programming it into an
FPGA.
- Reading a JEDEC file and programming it into a CPLD.
- Programming a .BIT file into an on-board configuration PROM.
- Programming a binary image into on-board SPI flash memory.
- Reading the contents of a PROM chip back to a file.
- Programming AVR microcontrollers.
.
The functionality of xc3sprog is similar to that of Xilinx IMPACT. There are
also similarities with other free JTAG tools, such as UrJTAG. However,
xc3sprog has a number of advantages:
.
- xc3sprog is free software.
- It is a command-line tool.
- It works on Linux without the need to install binary "cable-drivers".
(Although some types of JTAG cables need to load firmware.)
- It uses an optional configuration file to recognize new JTAG devices.
- It contains programming algorithms for the supported devices, enabling
the direct use of binary files (.BIT / JEDEC) from design tools (as opposed
to intermediate SVF/STAPLE files).
|
